part with

Related to part with: pertain to, run by, in consequence, pick up on, in line with, fall out with

part with (someone or something)

1. To relinquish, let go of, or give up someone or something. My dad does everything in his power not to part with his money, so we don't expect to get anything we don't absolutely need. I hate to part with this dress, but if you really want it, you can have it.
2. To separate or depart from someone or something; to stop associating with someone or something. I was so surprised to learn that he was parting with the agency—he'd been with them for nearly ten years! John parted with Bill after it came to light that Bill didn't want to ever have kids.
See also: part
Farlex Dictionary of Idioms.

part with someone or something

to give up or let go of someone or something. She did not want to part with her friend. I could never part with my books.
See also: part
McGraw-Hill Dictionary of American Idioms and Phrasal Verbs.

part with

Give up, let go of, relinquish, as in Janice hated to part with her cat, but the landlord wouldn't allow pets. [Mid-1300s]
See also: part
The American Heritage® Dictionary of Idioms by Christine Ammer.

part with

v.
1. To leave the company of someone; go away from someone: After months of negotiations, we've decided to part with the company.
2. To give up or let go of something; relinquish something: It's hard for me to part with old mementos.
See also: part
The American Heritage® Dictionary of Phrasal Verbs.
See also:
  • part with (someone or something)
  • sacrifice (someone or something) for (someone or something else)
  • sacrifice for
  • surrender
  • surrender (someone or something) to (someone or something)
  • surrender to
  • hand (something) to (someone) on a plate
  • hand something to somebody on a plate
  • demand (something) of (someone or something)
  • demanding
References in periodicals archive
The process utilizes two sheets of material, which are formed in separate molds while being simultaneously fused or "knitted" together under pressure to make a part with hollow sections.
Besides saving scrap, cycle time with suction molding is "nearly half" that of molding a comparable part with a conventional falling parison, Tahara says.
But what really makes success or failure in lost-core tool design is whether the tool makes a part with absolute repeatability in an acceptable cycle time.
One press making a large part with a multi-section core may need two core-making and melt-out systems to provide a continuous cycle, while a small part like a BMW impeller water pump uses one core-making system and a 15-ft glycol melt-out tank for three presses.
Getting all of the core to drain out of a part with a complex shape can be a problem, and some parts may have to rotate in the bath.